Data DLI 7200 Spécifications télécharger pdf (Page 30)

DLI 7200 Product Manual Rev. 3

SAM Card Installation

Part of the DLI 2-in-1 Module is an RFID Reader that requires a SAM Card to function correctly.

The SAM Card slot is found on the back of the 2-in-1 Module and has special instructions for

installation.

Warning! Do not install/remove module while unit is powered on or plugged in

to AC. ATTENTION! When removing the 2-in-1 module, please be aware of

exposed components. Use non-conductive tools. Do not remove module near

any liquids or debris.

1. Power down your DLI 7200 properly and remove AC (if plugged in).

2. Remove the 2 screws holding the 2-in-1 Module to the unit. Please be mindful of any

attached wires.

3. On the back of the 2-in-1 there is a SAM Card slot. Follow the instructions on the SAM

Card slot.

4. Lastly, line up the 2-in-1 Module on the back of the DLI 7200 and screw the device back

down. DO NOT over tighten.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 44 45

Pas de commentaire

Data DLI 7200 Spécifications Page 30